How to debug cement mortar mixer
1. When operating, first turn on the power.
2. Push the button switch to the program control position, that is, a slow turn-stop-fast turn procedure is automatically completed. If the twist switch and the manual position are set, the manual three-position switch completes the above actions, and the left and right handles can be used to make the skateboard. Drive the stirring pot along the dovetail rail of the column up and down, move up for stirring, and move down to remove the stirring pot. The stirring pot rotates and locks with the eccentric groove of the slide plate.
3, before starting the boot to do a good job before the preparation and test and adjustment.
4, the controller's acceptance and electrical operation methods.
5, pay attention to keep the whole machine and the controller clean, after each use, stirring leaves, pots should be cleaned and wiped in a timely manner, electrical parts should avoid severe vibration, away from water and high temperature, pay attention to dust.
6. After the operation is completed, the person who turns off the power can leave.
How to debug the working principle of the cement mortar mixer The two-speed motor transmits the power to the worm in the gear box through the shaft sleeve, then passes the worm wheel and a pair of gears to the spindle and decelerates. The main shaft drives the eccentric seat to rotate synchronously, so that the stirring blade fixed on the eccentric seat revolves. At the same time, the stirring blade completes the rotation motion around the fixed ring gear through the planetary gear at the upper end of the leaf shaft. The stirring pot and the support are rotated and locked by an eccentric groove, and if sand is added into the sand tank, the sand can be automatically added or manually added at a predetermined time. The handle is used for lifting and positioning the position of the stirring pot. 1. Adjustment:
Before the machine leaves the factory, the working gap between the stirring blade and the stirring pot has been adjusted to the range of 3±1 mm. Adjust the working gap between the stirring blade and the stirring pot, and loosen the adjusting nut to move the blade up and down to the correct clearance, and then tighten the adjustment nut. Measured by random rods in the gap.
(1) The workplace should be kept clean. After each use, the mortar inside and outside of the mixing blade and the stirring pot should be completely removed, and the mortar and dirt scattered and splashed on the machine should be cleaned. After drying, put on the cover. Prevent dust.
(2) The machine has no external filler hole. In the transmission case, the worm wheel pays, the gear and the bearing and other moving parts add butter once a quarter. Plus sometimes, the cover of the transmission box can be opened. Between the bearing and the column guide rails, the oil lifting and lubrication mechanism should be regularly dripped and the annual maintenance. Once, all the machine is cleaned and filled with oil and grease.
(3) When the machine is running, there is metal impact noise. Check whether the clearance between the stirring blade and the stirring pot is normal.
(4) When using a stirring pot, gently handle it and do not arbitrarily collide so as to avoid deformation of the stirring pot.
(5) Always check the electrical insulation condition at 20 °C ± 5 °C Relative temperature 50% - 70% cold insulation resistance 7/5 ohms.
Sales Manager: Manager Liu
contact number
contact number
24 hours service call
QQ online customer service